How do you prime a pool pump

Ensure that your pump is not running.You need to be a little quick during this step.If the pump starts to lose its prime, close the valve quickly.Turn the pump motor on.The pool pump is essential.

As soon as the pump primes, you need to switch the intake valve back over to the pool intakes so you do not drain your spa.Check the water flow to your pump.Without it, pool water wouldn't be fit for swimming very long.Prime the pump at the beginning of each pool season.Turn on the water to the hose.

First of all, turn the pump system off, ideally by the mains.Turn the power back on and check to see that the water flow has returned to the strainer box.While the pool has been covered for the offseason, the water in the pump and lines may have evaporated or drained off.It's good to become familiar with steps involved in priming a pool pump, since it's necessary at various times, such as after replacing components of.With power to your pool turned off at the circuit breaker, turn your multiport valve.

If so, then use a screwdriver to remove it.Repeat this with any other lines.Also, it would help if you released the pressure from the system.The following are basic steps for priming a pool pump.What you want here is for the lines from the skimmer to the pump to be full of water in order to create suction.

Open the valve marked air relief at the top of the pool pump.Follow steps 1 to 8 for pools that include main drains and cartridge filter.Open the air relief valve.